resistance bridge

Adopting the methods of semi-bridge measurement and temperature self-compensation, the strain values were measured by YJ-25 static resistance strain set, balance box, and all these data were the averages of the readings under different classified loadings.

采用YJ-25静态电阻应变仪、平衡箱，并用半桥测量，温度自补偿方法测定应变值。

In this paper, a new concept of bridge type high temperature superconducting fault current limiter ( HTSFCL) with serial resistance is introduced, which is especially on the control system, and also the low-voltage short circuit experiments have been carried out.

本论文主要针对这种新型桥路型限流器的控制系统进行研究，并参与了380V/60A新型桥路型限流器的试验样机制作和短路故障限流实验。

The North Channel cable bridge was analyzed after taking measures, the results showed the wind resistance measures increased the stiffness of structure and controlled the buffeting of the bridge.

对南航道斜拉桥最大双悬臂状态增设抗风措施后的效果进行了验算，结果表明，所采用的抗风措施提高了结构的刚度，有利于控制抖振。

Measuring connection resistance and contact resistance by using open sided Bridge

用单臂电桥测量接线电阻和接触电阻

It is the key for the devices to select the film for material with large temperature coefficient of resistance and the detector structure of good thermal isolation ( i.e. bridge structure).

指出了选用具有大的电阻温度系数的膜电阻材料和优良的热绝缘结构（如桥式结构）是研制器件的关键。

The two-arm bridge measuring low resistance circuit of MCU control, multivibrator measuring electric capacity, auxiliary leveling bridge circuit, output display circuit are designed.

设计了单片机控制双臂电桥测量低电阻电路、多谐振荡测量电容电路、辅助调平电桥电路、输出显示等电路。

The approach is designed a group of temperature controlled switch circuit which control whether the parallel resistance is activated or not. Temperature signal is come from bridge voltage signal which is power supply by constant current source.

技术途径是设计一组温控开关电路来控制并联电阻器是否接入，温度信号来源于恒流源供电下的传感器桥压信号。

Measuring principle and sensitivity of non-balanced bridge is analyzed. A method of measuring temperature coefficient of resistance by this bridge has been discussed in this paper result is accurate.

本文分析了非平衡电桥的测量原理及灵敏度，提出了一种测量电阻温度系数的方法，实测结果说明该方法是正确的。

By means of proposing adjustment sensitivity of slide-wire Wheatstone bridge, the paper solves the problems of calculation of error of resistance measured by slide-wire Wheatstone bridge.

本文通过引人线式惠斯登电桥的调节灵敏度，解决了用线式惠斯登电桥测量电阻时误差计算中存在的问题。

TB. An ideal culture medium was found by using BACTEC MGIT 960 system, general tubes and a LGC number resistance bridge.

TB，因此利用Bactec MGIT960系统和试管培养对培养基进行重新选择，并用数字电桥检测了它们培养前后的电导变化情况，最后找到了一种较理想的培养基。

The calculated results provide credible technical guide to construction of Runyang Bridge and ensure wind resistance safety.

为确保大桥抗风安全，指导施工提供了可靠的技术指导。